D-Link DGS-1510 Series - Ipv4 Route Table

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
143
To view the following window, click L3 Features > IPv4 Static/Default Route, as shown below:
Figure 6-9 IPv4 Static/Default Route window
The fields that can be configured are described below:
Parameter Description
IP Address Enter the IPv4 address for this route here. Tick the Default Route
check box to use the default route as the IPv4 address.
Mask
Enter the IPv4 network mask for this route here.
Gateway
Enter the gateway address for this route here.
Backup State
Select the backup state option here. Options to choose from are
Primary, and Backup. When the Primary option is selected, the route
will be used as the primary route to the destination. When the Backup
option is selected, the route will be used as the backup route to the
destination.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv4 Route Table
This window is used to view and configure the IPv4 route table settings.
To view the following window, click L3 Features > IPv4 Route Table, as shown below:
Figure 6-10 IPv4 Route Table window