DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
15
The fields that can be configured for Error Disable Trap Settings are described below:
Parameter Description
Asserted
Select this option to enable or disable the notifications when entering
into the error disabled state.
Cleared
Select this option to enable or disable the notifications when exiting
from the error disabled state.
Notification Rate
Enter the number of traps per minute. The packets that exceed the
rate will be dropped. The value is between 0 and 1000.
Click the Apply button to accept the changes made.
The fields that can be configured for Error Disable Recovery Settings are described below:
Parameter Description
ErrDisable Cause Select the error disable causes here. Options to choose from are All,
Port Security, Storm Control, BPDU Attack Protection, Dynamic
ARP Inspection, DHCP Snooping, and Loopback Detect.
State
Select this option to enable or disable the auto-recovery for an error
port caused by the specified cause.
Interval
Enter the time between 5 and 86400 seconds to recover the port.
Click the Apply button to accept the changes made.
Jumbo Frame
This window is used to view and configure the Jumbo Frame size and settings. The Switch supports
jumbo frames. Jumbo frames are Ethernet frames with more than 1,518 bytes of payload. The Switch
supports jumbo frames with a maximum frame size of up to 9216 bytes.
To view the following window, click System > Port Configuration > Jumbo Frame, as shown below:
Figure 3-8 Jumbo Frame window
To Next Page
Loading...
