DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
84
Aging Destination Hit
Select to enable or disable the aging destination hit function.
Click the Apply button to accept the changes made.
After clicking the MAC Address Learning tab, at the top of the page, the following page will be available.
Figure 5-4 MAC Address Table Settings (MAC Address Learning) window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the range of ports that will be used for this configuration here.
State
Select to enable or disable the MAC address learning function on the
ports specified here.
Click the Apply button to accept the changes made.
MAC Address Table
This window is used to view the entries listed in the MAC address table.
To view the following window, click L2 Features > FDB > MAC Address Table, as shown below:
To Next Page
Loading...
