DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
277
from are Protect, Restrict, and Shutdown. Selecting Protect
specifies to drop all packets from the insecure hosts at the port-
security process level, but does not increment the security-violation
count. Selecting Restrict specifies to drop all packets from the
insecure hosts at the port-security process level and increments the
security-violation count and record the system log. Selecting
Shutdown specifies to shut down the port if there is a security
violation and record the system log.
Security Mode
Select the security mode option here. Options to choose from are
Permanent and Delete-on-Timeout. Selecting Permanent specifies
that under this mode, all learned MAC addresses will not be purged
out unless the user manually deletes those entries. Selecting Delete-
on-Timeout specifies that under this mode, all learned MAC
addresses will be purged out when an entry is aged out or when the
user manually deletes these entries.
Aging Time
Enter the aging time value used for auto-learned dynamic secured
addresses on the specified port here. This value must be between 0
and 1440 minutes.
Aging Type Select the aging type here. Options to choose from are Absolute and
Inactivity. Selecting Absolute specifies that all the secure addresses
on this port age out exactly after the time specified and is removed
from the secure address list. This is the default type. Selecting
Inactivity specifies that the secure addresses on this port age out only
if there is no data traffic from the secure source address for the
specified time period.
Click the Apply button to accept the changes made.
Port Security Address Entries
This window is used to view, clear and configure the port security address entries.
To view the following window, click Security > Port Security > Port Security Address Entries, as
shown below:
Figure 9-3 Port Security Address Entries window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
MAC Address
Enter the MAC address here.
VID
Enter the VLAN ID here. This value must be between 1 and 4094.
To Next Page
Loading...
