DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
381
Figure 13-16 Trace Route - IPv4 Trace Route Result window
Click the Back button to stop the trace route and return to the IPv4 Trace Route section.
Language Management
This window is used to install the language file to the Switch.
To view the following window, click Tools > Language Management, as shown below:
Figure 13-17 Language Management window
The fields that can be configured are described below:
Parameter Description
Language File Click the Browse button to navigate to the location of the firmware file
located on the local PC.
Click the Apply button to initiate the language pack installation.
Reset
This window is used to reset the Switch’s configuration to the factory default settings.
To view the following window, click Tools > Reset, as shown below:
To Next Page
Loading...
