DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
147
Click the Delete button to remove the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
IPv6 Static/Default Route
This window is used to view and configure the IPv6 static or default routes.
To view the following window, click L3 Features > IPv6 Static/Default Route, as shown below:
Figure 6-16 IPv6 Static/Default Route window
The fields that can be configured are described below:
Parameter Description
IPv6 Address/Prefix Length
Enter the IPv6 address and prefix length for this route here. Tick the
Default Route option to use the default route as the IPv6 address.
Interface VLAN
Enter the interface’s VLAN ID that will be associated with this route
here.
Next Hop IPv6 Address
Enter the next hop IPv6 address here.
Backup State
Select the backup state option here. Options to choose from are
Primary, and Backup. When the Primary option is selected, the route
is specified as the primary route to the destination. When the Backup
option is selected, the route is specified as the backup route to the
destination.
Click the Apply button to accept the changes made.
IPv6 Route Table
This window is used to view and configure the IPv6 route table.
To view the following window, click L3 Features > IPv6 Route Table, as shown below:
To Next Page
Loading...
