DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
61
IPv6 Address
Select and enter the IPv6 address of the equipment.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
IP Source Interface
This window is used to configure the IP source interface settings.
To view the following window, click Management > IP Source Interface, as shown below:
Figure 4-41 IP Source Interface window
The fields that can be configured are described below:
Parameter Description
Source Interface State Select to Enable or Disable the source interface feature’s global state
here.
Interface Type After enabling the Source Interface State option, select the interface
type here. The only option available is VLAN.
VID (1-4094) After selecting the VLAN as the Interface Type, enter the VLAN ID
used here. This value must be between 1 and 4094.
Click the Apply button to accept the changes made.
File System
Why use flash file system:
In old switch system, the firmware, configuration and log information are saved in a flash with fixed
addresses and size. This means that the maximum configuration file can only be 2Mb, and even if the
current configuration is only 40Kb, it will still take up 2Mb of flash storage space. The configuration file
number and firmware numbers are also fixed. A compatible issue will occur in the event that the
configuration file or firmware size exceeds the originally designed size.
Flash File System in our system:
The Flash File System is used to provide the user with flexible file operation on the Flash. All the firmware,
configuration information and system log information are stored in the Flash as files. This means that the
Flash space taken up by all the files are not fixed, it is the real file size. If the Flash space is enough, the
user could download more configuration files or firmware files and use commands to display Flash file
information, rename file names, and delete it. Furthermore, the user can also configure the boot up
runtime image or the running configuration file if needed.
To view this window, click Management > File System as shown below:
To Next Page
Loading...
