DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
95
The fields that can be configured are described below:
Parameter Description
VLAN Mode
Select the VLAN mode option here. Options to choose from are
Access, Hybrid, and Trunk.
Acceptable Frame
Select the acceptable frame behavior option here. Options to choose
from are Tagged Only, Untagged Only, and Admit All.
Ingress Checking After selecting Trunk as the VLAN Mode the following parameter will
be available. Select to enable or disable the ingress checking function.
Native VLAN
Tick the check box to enable the native VLAN function. Also select if
this VLAN supports Untagged or Tagged frames.
VID After ticking the Native VLAN check box, this option will be available.
Enter the VLAN ID used for this configuration here. This value must be
between 1 and 4094.
Action
Select the action that will be taken here. Options to choose from are
All, Add, Remove, Except, and Replace.
Allowed VLAN Range
Enter the allowed VLAN range information here.
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
Auto Surveillance VLAN
Auto Surveillance Properties
This window is used to configure the auto surveillance VLAN global settings and display the ports
surveillance VLAN information.
To view the following window, click L2 Features > VLAN > Auto Surveillance VLAN > Auto
Surveillance Properties, as shown below:
To Next Page
Loading...
