DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
45
RMON History Settings
This window is used to configure and display RMON MIB history statistics gathering on the specified port.
To view the following window, click Management > RMON > RMON History Settings, as shown below:
Figure 4-16 RMON History Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
Port
Select to choose the port.
Index
Enter the history group table index. The value is from 1 to 65535
Bucket Number
Enter Specifies the number of buckets specified for the RMON
collection history group of statistics. The range is from 1 to 65535. The
default value is 50.
Interval
Enter the time in seconds in each polling cycle. The range is from 1 to
3600.
Owner
Enter the owner string. The string can be up to 127 characters.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specified entry.
Click the Show Detail button to see the detail information of the specific port.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
After clicking the Show Detail button, the following window will appear.
Figure 4-17 RMON History Table window
Click the Back button to return to the previous window.
RMON Alarm Settings
This window is used to configure and display alarm entries to monitor an interface.
To Next Page
Loading...
