DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
358
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
Port
Select the port used for the configuration here.
Action
Select the action that will be taken here. Options to choose from are
Add and Delete.
Type
Select the type of RX power threshold. Options to choose from are
Low Alarm, Low Warning, High Alarm, and High Warning.
Power Unit Select the power unit here. Options to choose from are mW and dBm.
Value Enter the threshold value. When selecting mW in the Power Unit
drop-down list, this value must be between 0 and 6.5535. When
selecting dBm in the Power Unit drop-down list, this value must be
between -40 and 8.1647.
Click the Apply button to accept the changes made.
DDM Status Table
This window is used to display the current operating digital diagnostic monitoring parameters and their
values on the SFP module for specified ports.
To view the following window, click OAM > DDM > DDM Status Table, as show below:
Figure 10-8 DDM Status Table window
To Next Page
Loading...
