D-Link DGS-1510 Series - RADIUS Group Server Settings

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
294
and 20. By default, this value is 3. To disable this option, enter the
value 0.
Timeout
Enter the timeout value used here. This value must be between 1 and
255 seconds. By default, this value is 5 seconds.
Key Type
Select the key type that will be used here. Options to choose from are
Plain Text and Encrypted.
Key
Enter the key, used to communicate with the RADIUS server, here.
This key can be up to 32 characters long.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
RADIUS Group Server Settings
This window is used to view and configure the RADIUS group server settings.
To view the following window, click Security > RADIUS > RADIUS Group Server Settings, as shown
below:
Figure 9-29 RADIUS Group Server Settings window
The fields that can be configured are described below:
Parameter Description
Group Server Name
Enter the RADIUS group server’s name here. This name can be up to
15 characters long.
IP Address
Enter the group server’s IPv4 address here.
IPv6 Address
Enter the group server’s IPv6 address here.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specified entry.
Click the Detail button to view and configure more detailed settings for the RADIUS group server.
After clicking the Detail button, the following page will be available.