DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
336
Host Mode
Select the host mode option that will be associated with the selected
port(s) here. Options to choose from are Multi Host and Multi Auth. If
the port is operated in the multi-host mode, and if one of the hosts is
authenticated, then all other hosts are allowed to access the port.
According to 802.1X authentication, if the re-authentication fails or the
authenticated user logs off, the port will be blocked for a quiet period.
The port restores the processing of EAPOL packets after the quiet
period. If the port is operated in the multi-authenticated mode, then
each host needs to be authenticated individually to access the port. A
host is represented by its MAC address. Only the authorized host is
allowed to access.
VID List After selecting the Multi Auth option as the Host Mode, the following
parameter is available. Enter the VLAN ID used here. This is useful
when different VLANs on the Switch have different authentication
requirements. After the client is authenticated, the client will not be re-
authenticated when received from other VLANs. This option is useful
for trunk ports to do per-VLAN authentication control. When a port’s
authentication mode is changed to multi-host, the previous
authentication VLAN(s) on this port will be cleared.
CompAuth Mode
Select the compound authentication mode option here. Options to
choose from are Any, MAC-JWAC, and MAC-WAC. Selecting Any
specifies that if any of the authentication method (802.1X, MAC-based
Access Control, WAC, or JWAC) to passes, then pass. Selecting
MAC-JWAC specifies to verify MAC-based authentication first. If the
client passes, JWAC will be verified next. Both authentication methods
need to be passed. Selecting MAC-WAC specifies to verify MAC-
based authentication first. If the client passes, WAC will be verified
next. Both authentication methods need to be passed.
Max Users
Enter the maximum users value used here. This value must be
between 1 and 1000.
Periodic
Select to enable or disable periodic re-authentication for the selected
port here. This parameter only affects the 802.1X protocol.
ReAuth Timer
Enter the re-authentication timer value here. This value must be
between 1 and 65535 seconds. By default, this value is 3600 seconds.
Inactivity State Select to enable or disable the inactivity state here. Select the Time
option to enable this feature.
Inactivity Timer When the Inactivity State is enabled, enter the inactivity timer value
here. This value must be between 120 and 65535 seconds. This
parameter only affects the WAC and JWAC authentication protocols.
Restart
Enter the restart time value used here. This value must be between 1
and 65535 seconds.
Click the Apply button to accept the changes made.
Network Access Authentication Sessions Information
This window is used to view and clear the network access authentication session information.
To view the following window, click Security > Network Access Authentication > Network Access
Authentication Sessions Information, as shown below:
To Next Page
Loading...
