D-Link DGS-1510 Series - 5 Layer 2 Features; Fdb; Static FDB

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
82
5. Layer 2 Features
FDB
VLAN
Spanning Tree
Loopback Detection
Link Aggregation
L2 Multicast Control
LLDP
FDB
Static FDB
Unicast Static FDB
This window is used to view and configure the static unicast forwarding settings on the Switch.
To view the following window, click L2 Features > FDB > Static FDB > Unicast Static FDB, as shown
below:
Figure 5-1 Unicast Static FDB window
The fields that can be configured are described below:
Parameter Description
Port / Drop
Allows the selection of the port number on which the MAC address
entered resides This option could also drop the MAC address from the
unicast static FDB. When selecting Port, select the switch unit and
port number.
Unit Number
Select the switch unit that will be used for this configuration here, when
Port is selected in the previous drop-down list.
Port Number Select the port number used here, when Port is selected in the
previous drop-down list.
VID
Enter the VLAN ID on which the associated unicast MAC address
resides.
MAC Address
Enter the MAC address to which packets will be statically forwarded or
dropped. This must be a unicast MAC address.
Click the Apply button to accept the changes made.
Click the Delete All button to delete all the entries found in the display table.
Click the Delete button to remove the specified entry.