DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
29
Click the Apply button to accept the changes made.
The fields that can be configured for SNTP Server Setting are described below:
Parameter Description
IPv4 Address
Enter the IP address of the SNTP server which provides the clock
synchronization.
IPv6 Address
Enter the IPv6 address of the SNTP server which provides the clock
synchronization.
Click the Add button to add the SNTP server.
Click the Delete button to remove the specified entry.
Time Range
This window is used to view and configure the time range settings.
To view the following window, click System > Time Range, as shown below:
Figure 3-23 Time Range window
The fields that can be configured are described below:
Parameter Description
Range Name
Enter the name of the time range. This name can be up to 32
characters long.
From Week / To Week
Select the starting and ending days of the week that will be used for
this time range. Tick the Daily option to use this time range for every
day of the week. Tick the End Week Day option to use this time range
from the starting day of the week until the end of the week, which is
Sunday.
From Time / To Time
Select the starting and ending time of the day that will be used for this
time range. The first drop-down menu selects the hour and the second
drop-down menu selects the minute.
Click the Apply button to accept the changes made.
Click the Find button to locate a specific entry based on the information entered.
Click the Delete Periodic button to delete the periodic entry.
To Next Page
Loading...
