D-Link DGS-1510 Series - System Log Discriminator Settings

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
23
Figure 3-15 System Log Settings window
The fields that can be configured for Global State are described below:
Parameter Description
Source Interface State
Select this option to enable or disable the source interface’s global
state.
Type
Select the type of interface that will be used. Option to choose from is
VLAN.
VID
Enter the VLAN ID used here. The value is between 1 and 4094.
Click the Apply button to accept the changes made.
The fields that can be configured for Buffer Log Settings are described below:
Parameter Description
Buffer Log State
Select whether the enable or disable the buffer log’s global state here.
Options to choose from are Enable, Disabled, and Default. When
selecting the Default option, the buffer log’s global state will follow the
default behavior.
Severity
Select the severity value of the type of information that will be logged.
Options to choose from are 0 (Emergencies), 1 (Alerts), 2 (Critical),
3 (Errors), 4 (Warnings), 5 (Notifications), 6 (Informational), and 7
(Debugging).
Discriminator Name
Enter the discriminator name used here. This name can be up to 15
characters long.
Write Delay
Enter the interval for periodic writing of the logging buffer to FLASH.
This value must be between 0 and 65535 seconds. By default, this
value is 300 seconds. Tick the Infinite option, to disable the write
delay feature.
Click the Apply button to accept the changes made.
The fields that can be configured for Console Log Settings are described below:
Parameter Description
Console Log State
Select whether the enable or disable the console log’s global state
here.
Severity
Select the severity value of the type of information that will be logged.
Options to choose from are 0 (Emergencies), 1 (Alerts), 2 (Critical),
3 (Errors), 4 (Warnings), 5 (Notifications), 6 (Informational), and 7
(Debugging).
Discriminator Name
Enter the discriminator name used here. This name can be up to 15
characters long.
Click the Apply button to accept the changes made.
System Log Discriminator Settings
This window is used to view and configure the system log’s discriminator settings.
To view the following window, click System > System Log > System Log Discriminator Settings, as
shown below: