DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
18
Figure 3-10 PoE Status window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Description
Enter the text that describes the PD connected to a PoE interface. The
maximum length is 32 characters.
Click the Delete Description button to clear the setting in the corresponding Description field.
Click the Apply button to accept the changes made.
PoE Configuration
This window is used to configure the PoE port.
To view the following window, click System > PoE > PoE Configuration, as shown below:
To Next Page
Loading...
