D-Link DGS-1510 Series - Time and SNTP; Clock Settings; Time Zone Settings

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
26
Figure 3-19 System Attack Log window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
Click the Clear Attack Log button to clear the system attack log entries displayed in the table.
Time and SNTP
The Simple Network Time Protocol (SNTP) is a protocol for synchronizing computer clocks through the
Internet. It provides comprehensive mechanisms to access national time and frequency dissemination
services, organize the SNTP subnet of servers and clients, and adjust the system clock in each
participant.
Clock Settings
This window is used to configure the time settings for the Switch.
To view the following window, click System > Time and SNTP > Clock Settings, as shown below:
Figure 3-20 Clock Settings window
The fields that can be configured are described below:
Parameter Description
Time (HH:MM:SS)
Enter the current time in hours, minutes, and seconds.
Date (DD / MM / YYYY)
Enter the current day, month, and year to update the system clock.
Click the Apply button to accept the changes made.
Time Zone Settings
This window is used to configure time zones and Daylight Savings Time settings for SNTP.
To view the following window, click System > Time and SNTP > Time Zone Settings, as shown below: