DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
17
Figure 3-9 PoE System window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
Usage Threshold
Enter the usage threshold to generate a log and send the
corresponding standard notification. The range is from 1 to 99 percent.
Policy Preempt
Select this option to enable or disable the disconnection of PD which in
power-provisioned with lower priority in order to release the power to
the new connected PD with higher priority under power shortage
conditions.
Trap State
Select this option to enable or disable the sending of PoE notifications.
Click the Apply button to accept the changes made.
Click the Show Detail button to see the PoE system Parameters table at the bottom of the window.
After clicking the Show Detail button, the following table will appear.
PoE Status
This window is used to configure the description, and display the PoE status of each port.
To view the following window, click System > PoE > PoE Status, as shown below:
To Next Page
Loading...
