DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
340
CPU protect related counters of sub-interfaces.
Protocol Name
Select the protocol name option here. Options to choose from are
DHCP, ARP, DNS, GVRP, ICMPv4, ICMPv6-Neighbor, ICMPv6-Other,
IGMP, LACP, SNMP, SSH, STP, Telnet, TFTP, Web, 802.1X, and All.
Click the Clear button to clear the information based on the selections made.
Click the Clear All button to clear all the information in this table.
CPU Protect Sub-Interface
This window is used to view and configure the CPU protection sub-interface settings.
To view the following window, click Security > Safeguard Engine > CPU Protect Sub-Interface, as
shown below:
Figure 9-79 CPU Protect Sub-Interface window
The fields that can be configured for CPU Protect Sub-Interface are described below:
Parameter Description
Sub-Interface
Select the sub-interface option here. Options to choose from are
Manage, Protocol, and Route.
Rate Limit
Enter the rate limit value used here. This value must be between 0 and
1024 packets per second. Tick the No Limit option to disable the rate
limit.
Click the Apply button to accept the changes made.
The fields that can be configured for Sub-Interface Information are described below:
Parameter Description
Sub-Interface
Select the sub-interface option here. Options to choose from are
Manage, Protocol, and Route.
Click the Find button to locate a specific entry based on the information entered.
CPU Protect Type
This window is used to view and configure the CPU protection type settings.
To view the following window, click Security > Safeguard Engine > CPU Protect Type, as shown below:
To Next Page
Loading...
