DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
161
VID List
Select and enter the VLAN list value that will be matched with the class
map here. This value must be between 1 and 4094.
Click the Apply button to accept the changes made.
Click the Back button to return to the previous window.
Aggregate Policer
This window is used to view and configure the aggregate policer settings.
To view the following window, click QoS > Advanced Settings > Aggregate Policer, as shown below:
Figure 7-14 Aggregate Policer window
The fields that can be configured are described below:
Parameter Description
Aggregate Policer Name
Enter the aggregate policer’s name here.
Average Rate Enter the average rate value here. This value must be between 0 and
10000000 kbps.
Normal Burst Size Enter the normal burst size value here. This value must be between 0
and 16384 Kbytes.
Maximum Burst Size
Enter the maximum burst size value here. This value must be between
0 and 16384 Kbytes.
Confirm Action
Select the confirm action here. The confirm action specifies the action
to take on green color packets. If the confirm action is not specified,
the default action is to Transmit. Options to choose from are Drop,
Set-DSCP-Transmit, Set-1P-Transmit, Transmit, and Set-DSCP-1P.
When selecting the Drop option, the packet will be dropped.
When selecting the Set-DSCP-Transmit option, enter the IP DSCP
value in the space provided. This value sets the IP differentiated
services code point (DSCP) value and transmits the packet with the
new IP DSCP value.
When selecting the Set-1P-Transmit option, enter the 1P transmit
value in the space provided. This value sets the 802.1p value and
transmits the packet with the new value.
When selecting the Set-DSCP-1P option, enter the IP DSCP and 1P
transmit values in the spaces provided.
When selecting the Transmit option, packets will be transmitted
unaltered.
To Next Page
Loading...
