DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
128
Figure 5-51 LLDP Port Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Subtype Select the subtype of LLDP TLV(s). Options to choose from are MAC
Address, and Local.
Admin State
Select the local LLDP agent and allow it to send and receive LLDP
frames on the port. Options to choose from are TX, RX, TX and RX,
and Disabled.
TX - The local LLDP agent can only transmit LLDP frames.
RX - The local LLDP agent can only receive LLDP frames.
TX and RX - The local LLDP agent can both transmit and receive
LLDP frames.
Disabled - The local LLDP agent can neither transmit nor receive
LLDP frames.
The default value is TX and RX.
IP Subtype
Select the type of the IP address information to be sent. Options to
choose from are All, IPv4 and IPv6.
Action
Select this option to enable or disable the action field
Address
Enter the IP address that will be sent.
Click the Apply button to accept the changes made.
NOTE: The IPv4 or IPv6 address entered here should be an existing LLDP management IP
address.
To Next Page
Loading...
