DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
116
Figure 5-40 IGMP Snooping Groups Settings
The fields that can be configured for IGMP Snooping Static Groups Settings are described below:
Parameter Description
VID
Enter a VLAN ID of the multicast group.
Group Address
Enter an IP multicast group address.
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
VID
Click the radio button and enter a VLAN ID of the multicast group.
Group Address
Click the radio button and enter an IP multicast group address.
Click the Apply button to accept the changes made.
Click the Delete button to remove the specified entry.
Click the Find button to locate a specific entry based on the information entered.
Click the Find All button to view all the entries.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
The fields that can be configured for IGMP Snooping Groups Table are described below:
Parameter Description
VID
Click the radio button and enter a VLAN ID of the multicast group.
Group Address
Click the radio button and enter an IP multicast group address.
Click the Find button to locate a specific entry based on the information entered.
Click the Find All button to view all the entries.
IGMP Snooping Mrouter Settings
This window is used to configure the specified interface(s) as the multicast router ports or as forbidden to
be multicast router ports on the Switch.
To Next Page
Loading...
