DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
122
Report Suppression
Select this option to enable or disable the report suppression.
Suppression Time
Enter the interval of suppressing duplicate MLD reports or leaves. The
range is from 1 to 300.
Proxy Reporting
Select this option to enable or disable the proxy-reporting function.
Source Address Enter the source IP of proxy reporting. This is available when Enabled
is selected in Proxy Reporting.
Mrouter Port Learning
Select this option to enable or disable Mrouter port learning.
Querier State
Select this option to enable or disable the querier state.
Query Version
Select the general query packet version sent by the MLD snooping
querier. Options to choose from are 1, and 2.
Query Interval
Enter the interval at which the MLD snooping querier sends MLD
general query messages periodically.
Max Response Time
Enter the maximum response time, in seconds, advertised in MLD
snooping queries. The range is 1 to 25.
Robustness Value
Enter the robustness variable used in MLD snooping.
Last Listener Query Interval
Enter the interval at which the MLD snooping querier sends MLD
group-specific or group-source-specific (channel) query messages.
Click the Apply button to accept the changes made.
MLD Snooping Groups Settings
This window is used to configure and view the MLD snooping static group, and view MLD snooping group.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD
Snooping Groups Settings, as shown below:
Figure 5-46 MLD Snooping Group Settings window
The fields that can be configured for MLD Snooping Static Groups Settings are described below:
Parameter Description
VID
Enter a VLAN ID of the multicast group.
To Next Page
Loading...
