DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
166
Figure 7-17 Policy Map (View Rules) window
Click the Set Action button to configure the action for the policy map.
Click the Policer button to configure the policer action for the policy map.
Click the Delete button to remove the specific entry.
After clicking the Set Action button, the following window will appear.
Figure 7-18 Set Action window
The fields that can be configured are described below:
Parameter Description
None
Select this option to match nothing to this policy map.
Specify
Select the option to match something to this policy map.
New Precedence
Select a new precedence for the packet. This value must be between 0
and 7. Tick the IPv4 only to only mark IPv4 precedence. Setting the
precedence will not affect the CoS queue selection.
New DSCP
Select a new DSCP for the packet. This value must be between 0 and
63. Tick the IPv4 only to only mark IPv4 precedence. Setting DSCP
will not affect the CoS queue selection.
New CoS
Select a new CoS value for the packet. This value must be between 0
and 7. Setting CoS will not affect the CoS queue selection.
New CoS Queue
Select a new CoS queue for the packet. This value must be between 0
To Next Page
Loading...
