DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
186
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Destination
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
IP Precedence
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
ToS
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
DSCP
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Time Range
Enter the name of the time range to associate with this ACL rule.
Action
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
After selecting the IP-in-IP option as the Protocol Type, the following section will appear.
Figure 8-16 ACL Configuration Wizard (Add Rule for IPv4 ACL) IP-in-IP window
To Next Page
Loading...
