DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
223
the Host option is selected, enter the source host’s IP address here.
When the IP option is selected, the Wildcard option will also be
available. Enter the group of source IP addresses by using a wildcard
bitmap. The bit corresponding to the bit value 1 will be ignored. The bit
corresponding to the bit value 0 will be checked.
Destination
Select and enter the destination information here. Options to choose
from are Any, Host, and IP. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s IP
address here. When the IP option is selected, the Wildcard option will
also be available. Enter the group of destination IP addresses by using
a wildcard bitmap. The bit corresponding to the bit value 1 will be
ignored. The bit corresponding to the bit value 0 will be checked.
IP Precedence
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
ToS
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
DSCP
Select or enter the DSCP value used here. This value must be
between 0 and 63.
Time Range
Enter the name of the time range to associate with this ACL rule.
After selecting the None option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-54 Extended IP ACL (Add Rule) None window
The dynamic fields that can be configured are described below:
Parameter Description
Fragments Select the Fragments option to include packet fragment filtering.
Source
Select and enter the source information here. Options to choose from
are Any, Host, and IP. When the Any option is selected, any source
To Next Page
Loading...
