DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
231
Sequence No.
Enter the ACL rule number here. This value must be between 1 and
65535. If this value is not specified, the system will automatically
generate an ACL rule number for this entry.
Action
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Protocol Type Select the protocol type option here. Options to choose from are TCP,
UDP, ICMP, Protocol ID, ESP, PCP, SCTP, and None.
After selecting the TCP option as the Protocol Type, the following page and parameters will be available,
as shown below:
Figure 8-67 Extended IPv6 ACL (Add Rule) TCP window
The dynamic fields that can be configured are described below:
Parameter Description
Source
Select and enter the source information here. Options to choose from
are Any, Host, and IPv6. When the Any option is selected, any source
traffic will be evaluated according to the conditions of this rule. When
the Host option is selected, enter the source host’s IPv6 address here.
When the IPv6 option is selected, the Prefix Length option will also be
available. Enter the source IPv6 address and prefix length value in the
spaces provided.
Destination
Select and enter the destination information here. Options to choose
from are Any, Host, and IPv6. When the Any option is selected, any
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s
IPv6 address here. When the IPv6 option is selected, the Prefix
Length option will also be available. Enter the destination IPv6
address and prefix length value in the spaces provided.
To Next Page
Loading...
