DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
247
This is a dynamic page. Every selection made in the Protocol Type option will change the bottom part of
this window.
The fixed fields that can be configured are described below:
Parameter Description
Sequence No.
Enter the ACL rule number here. This value must be between 1 and
65535. If this value is not specified, the system will automatically
generate an ACL rule number for this entry.
Action
Select the action that this rule will take here. Options to choose from
are Permit and Deny.
Protocol Type Select the protocol type option here. Options to choose from are TCP,
UDP, ICMP, EIGRP, ESP, GRE, IGMP, OSPF, PIM, VRRP, IP-in-IP,
PCP, Protocol ID, and None.
After selecting the TCP option as the Protocol Type, the following page and parameters will be available,
as shown below:
Figure 8-87 Extended Expert ACL (Add Rule) TCP window
The dynamic fields that can be configured are described below:
Parameter Description
Source IP Address
Select and enter the source information here. Options to choose from
To Next Page
Loading...
