DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
263
destination traffic will be evaluated according to the conditions of this
rule. When the Host option is selected, enter the destination host’s
MAC address here. When the MAC option is selected, the Wildcard
option will also be available. Enter the destination MAC address and
wildcard value in the spaces provided.
IP Precedence
Select the IP precedence value used here. Options to choose from are
0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override),
5 (critical), 6 (internet), and 7 (network).
ToS
After selecting the IP precedence value, select the Type-of-Service
(ToS) value that will be used here. Options to choose from are 0
(normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (max-
throughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15.
DSCP
Select or enter the DSCP value used here. This value must be
between 0 and 63.
VID
Enter the VLAN ID that will be associated with this ACL rule here. This
value must be between 1 and 4094.
CoS
Select the Class of Service (CoS) value here. Options to choose from
are from 0 to 7.
Time Range
Enter the name of the time range to associate with this ACL rule.
After selecting the IP-in-IP option as the Protocol Type, the following page and parameters will be
available, as shown below:
Figure 8-97 Extended Expert ACL (Add Rule) IP-in-IP window
The dynamic fields that can be configured are described below:
Parameter Description
Fragments Select the Fragments option to include packet fragment filtering.
Source IP Address
Select and enter the source information here. Options to choose from
To Next Page
Loading...
