DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
299
When DHCP snooping station move is enabled, the dynamic DHCP
snooping binding entry with the same VLAN ID and MAC address on
the specific port can move to another port if it detects that a new
DHCP process belong to the same VLAN ID and MAC address.
Click the Apply button to accept the changes made.
DHCP Snooping Port Settings
This window is used to view and configure the DHCP snooping port settings.
To view the following window, click Security > IMPB > IPv4 > DHCPv4 Snooping > DHCP Snooping
Port Settings, as shown below:
Figure 9-37 DHCP Snooping Port Settings window
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
Entry Limit
Enter the entry limit value here. This value must be between 0 and
1024. Tick the No Limit option to disable the function.
Rate Limit
Enter the rate limit value here. This value must be between 1 and 300.
Tick the No Limit option to disable the function.
To Next Page
Loading...
