DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
302
To view the following window, click Security > IMPB > IPv4 > DHCPv4 Snooping > DHCP Snooping
Binding Entry, as shown below:
Figure 9-40 DHCP Snooping Binding Entry window
The fields that can be configured are described below:
Parameter Description
MAC Address
Enter the MAC address of the DHCP snooping binding entry here.
VID
Enter the VLAN ID of the DHCP snooping binding entry here. This
value must be between 1 and 4094.
IP Address
Enter the IP address of the DHCP snooping binding entry here.
Unit
Select the switch unit that will be used for this configuration here.
Port
Select the appropriate port used for the configuration here.
Expiry
Enter the expiry time value used here. This value must be between 60
and 4294967295 seconds.
Click the Add button to add a new entry based on the information entered.
Click the Delete button to remove the specified entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
Dynamic ARP Inspection
ARP Access List
This window is used to view and configure the dynamic ARP inspection settings.
To view the following window, click Security > IMPB > IPv4 > Dynamic ARP Inspection > ARP Access
List, as shown below:
To Next Page
Loading...
