EasyManua.ls Logo

D-Link DGS-1510 Series - Page 386

D-Link DGS-1510 Series
430 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
378
Target IPv4 Address
Select and enter an IP address to be pinged.
Domain Name
Select and enter the domain name of the system to discover.
Ping Times
Enter the number of times desired to attempt to Ping the IPv4 address
configured in this window. Users may enter a number of times between
1 and 255. Tick the Infinite check box to keep sending ICMP Echo
packets to the specified IP address until the program is stopped.
Timeout
Select a timeout period between 1 and 99 seconds for this Ping
message to reach its destination. If the packet fails to find the IP
address in this specified time, the Ping packet will be dropped.
Source IPv4 Address
Enter the source IPv4 address. If the current switch has more than one
IP address, you can enter one of them to this field. When entered, this
IPv4 address will be used as the packets’ source IP address sent to
the remote host, or as primary IP address.
The fields that can be configured for IPv6 Ping are described below:
Parameter Description
Target IPv6 Address
Enter an IPv6 address to be pinged.
Ping Times
Enter the number of times desired to attempt to Ping the IPv6 address
configured in this window. Users may enter a number of times between
1 and 255. Tick the Infinite check box to keep sending ICMP Echo
packets to the specified IPv6 address until the program is stopped.
Timeout
Select a timeout period between 1 and 99 seconds for this Ping
message to reach its destination. If the packet fails to find the IP
address in this specified time, the Ping packet will be dropped.
Source IPv6 Address
Enter the source IPv6 address. If the current switch has more than one
IPv6 address, you can enter one of them to this field. When entered,
this IPv6 address will be used as the packets’ source IP address sent
to the remote host, or as primary IP address.
Click the Start button to initiate the Ping Test for each individual section.
After clicking the Start button in IPv4 Ping section, the following IPv4 Ping Result section will appear:
Figure 13-13 Ping - IPv4 Ping Result window

Table of Contents

Other manuals for D-Link DGS-1510 Series

Related product manuals