DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide
89
The fields that can be configured are described below:
Parameter Description
Unit
Select the switch unit that will be used for this configuration here.
From Port / To Port
Select the appropriate port range used for the configuration here.
GVRP Status
Select this option to enable or disable the GVRP port status. This
enables the port to dynamically become a member of a VLAN. By
default, this option is disabled.
Join Time
Enter the Join Time value in centiseconds. This value must be
between 10 and 10000 centiseconds. By default, this value is 20
centiseconds.
Leave Time
Enter the Leave Time value in centiseconds. This value must be
between 10 and 10000 centiseconds. By default, this value is 60
centiseconds.
Leave All Time
Enter the Leave All Time value in centiseconds. This value must be
between 10 and 10000 centiseconds. By default, this value is 1000
centiseconds.
Click the Apply button to accept the changes made.
GVRP Advertise VLAN
This window is used to view and configure the GVRP advertised VLAN settings.
To view the following window, click L2 Features > VLAN > GVRP > GVRP Advertise VLAN, as shown
below:
Figure 5-11 GVRP Advertise VLAN window
The fields that can be configured are described below:
To Next Page
Loading...
