130 | Data Center Bridging (DCB)
www.dell.com | support.dell.com
To create a QoS output policy that allocates different amounts of bandwidth to the different traffic types/
dot1p priorities assigned to a queue and apply the output policy to the interface, follow these steps.
Step Task Command Command Mode
1 Create a QoS output policy.
Maximum: 32 alphanumeric characters.
qos-policy-output
output-policy-name
CONFIGURATION
2 Configure the percentage of bandwidth to be
allocated to the dot1p priority/queue traffic in
the associated L2 class map.
Default: None.
bandwidth-percentage
percentage
QoS OUTPUT POLICY
3 Repeat Step 2 to configure bandwidth
percentages for other priority queues on the
port.
bandwidth-percentage
percentage
QoS OUTPUT POLICY
4 Create a priority group for strict-priority
scheduling.
scheduler strict
QoS OUTPUT POLICY
5 Exit QoS Output Policy Configuration mode.
exit
QoS OUTPUT POLICY
6 Enter INTERFACE Configuration mode.
interface type slot/port
CONFIGURATION
7 Apply the QoS output policy with the
bandwidth percentage for specified priority
queues to an egress interface.
service-policy output
output-policy-name
INTERFACE
To Next Page
Loading...
