Dell Force10 MXL Blade - Configure RMON Collection History; Enable an RMON MIB Collection History Group

458 | Remote Monitoring (RMON)
www.dell.com | support.dell.com
Configure RMON Collection History
To enable the RMON MIB history group of statistics collection on an interface, use the rmon collection
history
command in CONFIGURATION INTERFACE (conf-if) mode. To remove a specified RMON
history group of statistics collection, use the
no rmon collection history command.
Enable an RMON MIB Collection History Group
The command in Figure 26-4 enables an RMON MIB collection history group of statistics with an ID
number of 20 and an owner of “john”, both the sampling interval and the number of buckets use their
respective defaults.
Figure 26-4. rmon collection history Command Example
Command Syntax Command Mode Purpose
[no] rmon collection history {controlEntry
integer} [owner owner-string] [buckets
bucket-number]
[interval seconds]
CONFIGURATION
INTERFACE
(conf-if)
controlEntry: Specifies the RMON group of statistics
using a value.
integer: A value from 1 to 65,535 that identifies the
RMON group of statistics. The value must be a
unique index in the RMON History Table.
owner: (Optional) Specifies the name of the owner of
the RMON group of statistics. The default is a
null-terminated string.
owner-string: (Optional) Records the name of the
owner of the RMON group of statistics.
buckets: (Optional) Specifies the maximum number
of buckets desired for the RMON collection history
group of statistics.
bucket-number: (Optional) A value associated with
the number of buckets specified for the RMON
collection history group of statistics. The value is
limited to from 1 to 1000. Default is 50 (as defined in
RFC-2819).
interval: (Optional) Specifies the number of seconds
in each polling cycle.
seconds: (Optional) The number of seconds in each
polling cycle. The value is ranged from 5 to 3,600
(Seconds). The default is 1,800 as defined in
RFC-2819.
FTOS(conf-if-te-0/40)#rmon collection history controlEntry 20 owner
john