Dell Force10 MXL Blade - Enabling LLDP; Disabling and Undoing LLDP

322 | Link Layer Discovery Protocol (LLDP)
www.dell.com | support.dell.com
Figure 18-7. Configuration and Interface mode LLDP Commands
Enabling LLDP
LLDP is disabled by default. You can enable and disable LLDP globally or per interface. If you enable
LLDP globally, all up interfaces send periodic LLDPDUs. To enable LLDP, follow these steps:
Disabling and Undoing LLDP
• Disable LLDP globally or for an interface using the disable command.
• Undo an LLDP configuration by preceding the relevant command with the keyword
no command.
Step Task Command Command Mode
1 Enter Protocol LLDP mode.
protocol lldp
CONFIGURATION or INTERFACE
2 Enable LLDP.
no disable
PROTOCOL LLDP
R1(conf)#protocol lldp
R1(conf-lldp)#?
advertise Advertise TLVs
dcbx Configure Dcbx Parameters
disable Disable LLDP protocol globally
end Exit from configuration mode
exit Exit from LLDP configuration mode
fcoe Configure priority bits for FCoE traffic
hello LLDP hello configuration
iscsi Configure priority bits for ISCSI traffic
mode LLDP mode configuration (default = rx and tx)
multiplier LLDP multiplier configuration
no Negate a command or set its defaults
show Show LLDP configuration
R1(conf-lldp)#exit
R1(conf)#interface tengigabitethernet 1/31
R1(conf-if-te-1/31)#protocol lldp
R1(conf-if-te-1/31-lldp)#?
advertise Advertise TLVs
dcbx Configure Dcbx Parameters
disable Disable LLDP protocol on this interface
end Exit from configuration mode
exit Exit from LLDP configuration mode
hello LLDP hello configuration
mode LLDP mode configuration (default = rx and tx)
multiplier LLDP multiplier configuration
no Negate a command or set its defaults
show Show LLDP configuration
no Negate a command or set its defaults
show Show LLDP configuration
R1(conf-if-te-1/31-lldp)#