Dell Force10 MXL Blade - Telnet to Another Network Device; Lock CONFIGURATION Mode

66 | Management
www.dell.com | support.dell.com
Figure 4-7. Configuring EXEC Timeout
Telnet to Another Network Device
To telnet to another device (Figure 4-8):
Figure 4-8. Telnet to Another Network Device
Lock CONFIGURATION Mode
FTOS allows multiple users to make configurations at the same time. You can lock CONFIGURATION
mode so that only one user can be in CONFIGURATION mode at any time (Figure 4-9).
Task Command Syntax Command Mode
Telnet to the stack-unit.You do not need to configure the management
port on the stack-unit to be able to telnet to it.
telnet-peer-stack-unit
EXEC Privilege
Telnet to a device with an IPv4 address. If you do not enter an IP address,
FTOS enters a Telnet dialog that prompts you for one.
• Enter an IPv4 address in dotted decimal format (A.B.C.D)
telnet [ip-address]
EXEC Privilege
FTOS(conf)#line con 0
FTOS(conf-line-console)#exec-timeout 0
FTOS(conf-line-console)#show config
line console 0
exec-timeout 0 0
FTOS(conf-line-console)#
FTOS# telnet 10.11.80.203
Trying 10.11.80.203...
Connected to 10.11.80.203.
Exit character is '^]'.
Login:
Login: admin
Password:
FTOS>exit
FTOS#telnet 2200:2200:2200:2200:2200::2201
Trying 2200:2200:2200:2200:2200::2201...
Connected to 2200:2200:2200:2200:2200::2201.
Exit character is '^]'.
FreeBSD/i386 (freebsd2.force10networks.com) (ttyp1)
login: admin
FTOS#