284 | iSCSI Optimization
www.dell.com | support.dell.com
Displaying iSCSI Optimization Information
Use the show commands in Table 15-2 to display information on iSCSI optimization.
Figure 15-2. show iscsi Command Example
5 (Optional) Configures DCBX to send iSCSI TLV
advertisements. You can configure iSCSI TLVs to be
sent either globally or on a specified interface. The
interface configuration takes priority over global
configuration.
Default: Enabled.
[no] advertise dcbx-app-tlv
iscsi
CONFIGURATION
or
INTERFACE
6 (Optional) Configures the priority bitmap to be
advertised in iSCSI application TLVs.
Default: 4 (0x10 in the bitmap).
[no] iscsi priority-bits
CONFIGURATION
7 (Optional) Enter interface configuration mode to
configure the auto-detection of Compellent disk
arrays.
interface port-type slot/port CONFIGURATION
8 (Optional) Configures the autodetection of
Compellent arrays on a port.
Default: Compellent disk arrays are not detected.
[no] iscsi profile-compellent
INTERFACE
Table 15-2. Displaying iSCSI Optimization Information
Command Output
show iscsi (Figure 15-2) Displays the currently configured iSCSI settings.
show iscsi sessions (Figure 15-3) Displays information on active iSCSI sessions on the switch.
show iscsi sessions detailed [session isid]
(Figure 15-4)
Displays detailed information on active iSCSI sessions on the switch. To
display detailed information on specified iSCSi session, enter the session’s
iSCSi ID.
show run iscsi Displays all globally-configured non-default iSCSI settings in the current
FTOS session.
Step Task Command Command Mode
FTOS# show isci
iSCSI is enabled
iSCSI COS : dot1p is 4 no-remark
Session aging time: 10
Maximum number of connections is 256
------------------------------------------------
iSCSI Targets and TCP Ports:
------------------------------------------------
TCP Port Target IP Address
3260
860
To Next Page
Loading...
