Dell Force10 MXL Blade - Configure the Minimum Oper up Links in a Port Channel (LAG); Add or Remove a Port Channel from a VLAN

Interfaces | 237
Configure the Minimum oper up Links in a Port Channel (LAG)
You can configure the minimum links in a port channel (LAG) that must be in “oper up” status for the port
channel to be considered in “oper up” status. To configure the minimum links, use the following command
in INTERFACE mode:
Figure 13-14 shows an example of configuring five minimum “oper up” links in a port channel.
Figure 13-14. Example of Using the minimum-links Command
Add or Remove a Port Channel from a VLAN
As with other interfaces, you can add Layer 2 port channel interfaces to VLANs. To add a port channel to
a VLAN, you must place the port channel in Layer 2 mode (use the
switchport command).
To add a port channel to a VLAN, use either of the following commands:
To remove a port channel from a VLAN, use either of the following commands:
To see which port channels are members of VLANs, use the
show vlan command in EXEC Privilege mode.
Command Syntax Command Mode Purpose
minimum-links number
INTERFACE Enter the number of links in a LAG that must be in
“oper up” status.
Default: 1
Command Syntax Command Mode Purpose
tagged port-channel id number
INTERFACE
VLAN
Add the port channel to the VLAN as a tagged
interface. An interface with tagging enabled can
belong to multiple VLANs.
untagged port-channel id number INTERFACE
VLAN
Add the port channel to the VLAN as an untagged
interface. An interface without tagging enabled can
belong to only one VLAN.
Command Syntax Command Mode Purpose
no tagged port-channel id number
INTERFACE
VLAN
Remove the port channel with tagging enabled
from the VLAN.
no untagged port-channel id number INTERFACE
VLAN
Remove the port channel without tagging
enabled from the VLAN.
FTOS#config t
FTOS(conf)#int po 1
FTOS(conf-if-po-1)#minimum-links 5
FTOS(conf-if-po-1)#