Dell Force10 MXL Blade - Enable and Disable Sflow; Enable and Disable on an Interface; Sflow Show Commands

sFlow | 507
• The 802.1P source priority field is not filled in extended switch element in the sFlow datagram.
• Only the Destination and Destination Peer AS number are packed in the dst-as-path field in extended
gateway element.
• If the packet being sampled is redirected using policy-based routing (PBR), the sFlow datagram may
contain incorrect extended gateway and/or router information.
• The source VLAN field in the extended switch element is not packed in case of routed packet.
• The destination VLAN field in the extended switch element is not packed in case of multicast packet.
• On the MXL Switch, up to 700 packets can be sampled and processed per second.
Enable and Disable sFlow
By default, sFlow is disabled globally on the system. To enable sFlow globally, use the sflow enable
command in CONFIGURATION mode. To disable sFlow globally, use the no sflow enable command.
Enable and Disable on an Interface
By default, sFlow is disabled on all interfaces. To enable sFlow on a specific interface, use the sflow enable
command in INTERFACE mode. This command line interface (CLI) is supported on physical ports and
link aggregation group (LAG) ports. To disable sFlow on an interface, use the
no sflow enable command.
sFlow Show Commands
FTOS includes the following sFlow display commands:
• Show sFlow Globally
• Show sFlow on an Interface
• Show sFlow on a Stack Unit
Command Syntax Command Mode Usage
[no] sflow enable
CONFIGURATION Enable sFlow globally.
Command Syntax Command Mode Usage
[no] sflow enable
INTERFACE Enable sFlow on an interface.