EasyManua.ls Logo

Dell Force10 MXL Blade - Bare Metal Provisioning; Overview; Commands

Dell Force10 MXL Blade
690 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Data Center Bridging (DCB) | 141
DCBX Error Messages
An error in DCBX operation is displayed using the following syslog messages:
LLDP_MULTIPLE_PEER_DETECTED: DCBX is operationally disabled after detecting more than one DCBX
peer on the port interface.
LLDP_PEER_AGE_OUT: DCBX is disabled as a result of LLDP timing out on a DCBX peer interface.
DSM_DCBX_PEER_VERSION_CONFLICT: A local port expected to receive the IEEE, CIN, or CEE version
in a DCBX TLV from a remote peer but received a different, conflicting DCBX version.
DSM_DCBX_PFC_PARAMETERS_MATCH and DSM_DCBX_PFC_PARAMETERS_MISMATCH: A local DCBX port received
a compatible (match) or incompatible (mismatch) PFC configuration from a peer.
DSM_DCBX_ETS_PARAMETERS_MATCH and DSM_DCBX_ETS_PARAMETERS_MISMATCH: A local DCBX port received
a compatible (match) or incompatible (mismatch) ETS configuration from a peer.
LLDP_UNRECOGNISED_DCBX_TLV_RECEIVED: A local DCBX port received an unrecognized DCBX TLV from
a peer.
5 Configure the Application Priority TLVs to be advertised
on unconfigured interfaces with a manual port-role,
where:
fcoe enables the advertisement of FCoE in Application
Priority TLVs.
iscsi enables the advertisement of iSCSI in
Application Priority TLVs.
Default: Application Priority TLVs are enabled and
advertise FCoE and iSCSI.
Note: To disable TLV transmission, use the no form of the
command; for example, no advertise dcbx-appln-tlv iscsi.
For information about how to use FCoE and iSCSI, refer
to FIP Snooping and iSCSI Optimization.
[no] advertise dcbx-appln-tlv
{fcoe | iscsi}
PROTOCOL LLDP
6 Configure the FCoE priority advertised for the FCoE
protocol in Application Priority TLVs.
The priority-bitmap range is from 1 to FF.
Default: 0x8.
[no] fcoe priority-bits
priority-bitmap
PROTOCOL LLDP
7 Configure the iSCSI priority advertised for the iSCSI
protocol in Application Priority TLVs.
The priority-bitmap range is from 1 to FF.
Default: 0x10.
[no] iscsi priority-bits
priority-bitmap
PROTOCOL LLDP
Step Task Command Command Mode

Table of Contents

Other manuals for Dell Force10 MXL Blade

Related product manuals