Dell Force10 MXL Blade - Bulk Configuration Examples; Create a Single-Range; Create a Multiple-Range; Exclude Duplicate Entries

Interfaces | 239
To display all interfaces that have been validated under the interface range context, use the show range
command in Interface Range mode.
To display the running configuration only for interfaces that are part of interface range, use the
show
configuration
command in Interface Range mode.
Bulk Configuration Examples
The following are examples of using the interface range command for bulk configuration:
• Create a Single-Range
• Create a Multiple-Range
• Exclude Duplicate Entries
• Exclude a Smaller Port Range
• Overlap Port Ranges
• Commas
• Add Ranges
Create a Single-Range
Figure 13-15. Creating a Single-Range Bulk Configuration
Create a Multiple-Range
Figure 13-16. Creating a Multiple-Range Prompt
Exclude Duplicate Entries
Duplicate single interfaces and port ranges are excluded from the resulting interface range prompt.
Note: When creating an interface range, interfaces appear in the order they were entered and are not
sorted.
FTOS(conf)# interface range tengigabitethernet 5/1 - 23
FTOS(conf-if-range-te-5/1-23)# no shutdown
FTOS(conf-if-range-te-5/1-23)#
FTOS(conf)#interface range tengigabitethernet 3/0 , tengigabitethernet 2/1 - 47 , vlan 1000
FTOS(conf-if-range-te-2/1-47)#