508 | sFlow
www.dell.com | support.dell.com
Show sFlow Globally
To view sFlow statistics, use the following command (Figure 29-2):
Figure 29-2. show sflow Command Example
Show sFlow on an Interface
To view sFlow information on a specific interface, use the following command (Figure 29-3):
Figure 29-3. show sflow interface Command Example
Command Syntax Command Mode Purpose
show sflow
EXEC Display sFlow configuration information and statistics.
Command Syntax Command Mode Purpose
show sflow interface
interface-name
EXEC Display sFlow configuration information and statistics on a
specific interface.
FTOS#show sflow
sFlow services are enabled
Global default sampling rate: 32768
Global default counter polling interval: 20
1 collectors configured
Collector IP addr: 133.33.33.53, Agent IP addr: 133.33.33.116, UDP port: 6343
77 UDP packets exported
0 UDP packets dropped
165 sFlow samples collected
69 sFlow samples dropped due to sub-sampling
FTOS#
Indicates sFlow is globally enabled
FTOS#show sflow interface tengigabitethernet 1/16
Tengig 1/16
Configured sampling rate :8192
Actual sampling rate :8192
Sub-sampling rate :2
Counter polling interval :15
Samples rcvd from h/w :33
Samples dropped for sub-sampling :6
To Next Page
Loading...
