Dell Force10 MXL Blade - Synchronize Log Messages

60 | Management
www.dell.com | support.dell.com
Synchronize log messages
You can configure FTOS to filter and consolidate system messages for a specific line by synchronizing the
message output. Only the messages with a severity at or below the set level appear. This feature works on
the terminal and console connections available on the system.
To synchronize log messages, use these commands in the following sequence starting in
CONFIGURATION mode:
To view the logging synchronous configuration, enter the
show config command in LINE mode.
Step Command Syntax Command Mode Purpose
1
line {console 0 | vty number [end-number]}
CONFIGURATION Enter the LINE mode. Configure the
following parameters for the virtual
terminal lines:
•
number range: zero (0) to 9.
• end-number range: 1 to 8.
You can configure multiple virtual
terminals at one time by entering a number
and an end-number.
2
logging synchronous [level severity-level |
all] [limit]
LINE Configure a level and set the maximum
number of messages to be printed.
Configure the following optional
parameters:
• level severity-level range: 0 to 7.
Default is 2. Use the all keyword to
include all messages.
• limit range: 20 to 300. Default is 20.