Dell Force10 MXL Blade - Using a Pre-Defined Buffer Profile

660 | Debugging and Diagnostics
www.dell.com | support.dell.com
Figure 39-9. Displaying Buffer Profile Allocations
Using a Pre-Defined Buffer Profile
FTOS provides two pre-defined buffer profiles, one for single-queue (for example, non-QoS) applications,
and one for four-queue (for example, QoS) applications.
Task Command Mode
Apply one of two pre-defined buffer profiles for all port
pipes in the system.
buffer-profile global [1Q|4Q]
CONFIGURATION
FTOS#show running-config interface tengigabitethernet 2/0 !
interface TenGigabitEthernet 2/0
no ip address
mtu 9252
switchport
no shutdown
buffer-policy myfsbufferprofile
FTOS#show buffer-profile detail int tengig 0/10
Interface Tengig 0/10
Buffer-profile fsqueue-fp
Dynamic buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
6 3.00 256
7 3.00 256
FTOS#show buffer-profile detail fp-uplink stack-unit 0 port-set 0
Linecard 0 Port-set 0
Buffer-profile fsqueue-hig
Dynamic Buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
6 3.00 256
7 3.00 256