Dell Force10 MXL Blade - Enable Proxy ARP

268 | IPv4 Routing
www.dell.com | support.dell.com
To view the static entries in the ARP cache, use the show arp static command in EXEC privilege mode
(Figure 14-7).
Figure 14-7. show arp static Command Example
Enable Proxy ARP
By default, proxy ARP is enabled. To disable Proxy ARP, use the no proxy-arp command in INTERFACE
mode.
To re-enable proxy ARP, use the following command in INTERFACE mode:
To view if proxy ARP is enabled on the interface, use the
show config command in INTERFACE mode. If it
is not listed in the
show config command output, it is enabled. Only non-default information is displayed in
the
show config command output.
Command Syntax Command Mode Purpose
ip proxy-arp
INTERFACE Re-enable proxy ARP.
FTOS#show arp
Protocol Address Age(min) Hardware Address Interface VLAN CPU
-----------------------------------------------------------------------------------------
Internet 10.11.68.14 94 00:01:e9:45:00:03 Ma 0/0 - CP
Internet 10.11.209.254 0 00:01:e9:45:00:03 Ma 0/0 - CP
FTOS#