Dell Force10 MXL Blade - Apply a Privilege Level to a Terminal Line; Configure Logging; Log Messages in the Internal Buffer; Configuration Task List for System Log Management

Management | 55
To set a privilege level for a user:
Apply a Privilege Level to a Terminal Line
To set a privilege level for a terminal line:
Configure Logging
FTOS tracks changes in the system using event and error messages. By default, FTOS logs these messages
on:
• the internal buffer
• console and terminal lines
• any configured syslog servers
Log Messages in the Internal Buffer
All error messages, except those beginning with %BOOTUP (Message), are logged in the internal buffer.
Configuration Task List for System Log Management
The following sections include the configuration tasks for system log management:
• Disable System Logging
• Send System Messages to a Syslog Server
Task Command Syntax Command Mode
Configure a privilege level for a user.
username username privilege level
CONFIGURATION
Task Command Syntax Command Mode
Configure a privilege level for a terminal line.
privilege level level
LINE
Note: When you assign a privilege level between 2 and 15, access to the system begins at EXEC mode,
but the prompt is hostname#, rather than hostname>.
Message 1 BootUp Events
%BOOTUP:RPM0:CP %PORTPIPE-INIT-SUCCESS: Portpipe 0 enabled