Dell Force10 MXL Blade - Page 56

54 | Management
www.dell.com | support.dell.com
Figure 4-1. Create a Custom Privilege Level Apply a Privilege Level to a Username
FTOS(conf)#do show run privilege
!
FTOS(conf)#privilege exec level 3 capture
FTOS(conf)#privilege exec level 3 configure
FTOS(conf)#privilege exec level 4 resequence
FTOS(conf)#privilege exec level 3 clear arp-cache
FTOS(conf)#privilege exec level 3 clear arp-cache max-buffer-size
FTOS(conf)#privilege configure level 3 line
FTOS(conf)#privilege configure level 3 interface
FTOS(conf)#do telnet 10.11.80.201
[telnet output omitted]
FTOS#show priv
Current privilege level is 3.
FTOS#?
capture Capture packet
configure Configuring from terminal
disable Turn off privileged commands
enable Turn on privileged commands
exit Exit from the EXEC
ip Global IP subcommands
monitor Monitoring feature
mtrace Trace reverse multicast path from destination to source
ping Send echo messages
quit Exit from the EXEC
show Show running system information
[output omitted]
FTOS#config
[output omitted]
FTOS(conf)#do show priv
Current privilege level is 3.
FTOS(conf)#?
end Exit from configuration mode
exit Exit from configuration mode
interface Select an interface to configure
FTOS(conf)#interface ?
loopback Loopback interface
managementethernet Management Ethernet interface
null Null interface
port-channel Port-channel interface
range Configure interface range
tengigabitethernet TenGigabit Ethernet interface
vlan VLAN interface
FTOS(conf)#interface tengigabitethernet 1/1
FTOS(conf-if-te-1/1)#?
end Exit from configuration mode
exit Exit from interface configuration mode
FTOS(conf-if-te-1/1)#exit
FTOS(conf)#line ?
console Primary terminal line
vty Virtual terminal
FTOS(conf)#line vty 0
FTOS(conf-line-vty)#?
exit Exit from line configuration mode
FTOS(conf-line-vty)#