Dell Force10 MXL Blade - Set the Send and Receive Version

440 | Routing Information Protocol (RIP)
www.dell.com | support.dell.com
To add routes from other routing instances or protocols, use any of the following commands in ROUTER
RIP mode:
To view the current RIP configuration, use the
show running-config command in EXEC mode or the show
config
command in ROUTER RIP mode.
Set the Send and Receive Version
To specify the RIP version, use the version command in ROUTER RIP mode. To set an interface to receive
only one or the other version, use the
ip rip send version or the ip rip receive version commands in
INTERFACE mode.
To change the RIP version globally in FTOS, use the following command in ROUTER RIP mode:
To set one RIP version globally, use the
system command. This command sets the RIP version for RIP
traffic on the interfaces participating in RIP, unless the interface was specifically configured for a specific
RIP version.
To see whether the
version command is configured, use the show config command in ROUTER RIP mode.
To view the routing protocols configuration, use the
show ip protocols command in EXEC mode.
Command Syntax Command Mode Purpose
redistribute {connected | static} [metric metric-value]
[route-map
map-name]
ROUTER RIP Include directly connected or
user-configured (static) routes in RIP.
•
metric range: 0 to 16
• map-name: name of a configured route
map.
redistribute ospf process-id [match external {1 | 2} |
match internal] [metric
value] [route-map map-name]
ROUTER RIP Include specific OSPF routes in RIP.
Configure the following parameters:
• process-id range: 1 to 65535
• metric range: 0 to 16
• map-name: name of a configured route
map.
Command Syntax Command Mode Purpose
version {1 | 2}
ROUTER RIP Set the RIP version sent and received on the system.