Dell Force10 MXL Blade - Spanning Tree Protocol (STP); Overview; Commands

Uplink Failure Detection (UFD) | 619
Sample Configuration: Uplink Failure Detection
Figure 35-7 shows a sample configuration of Uplink Failure Detection on a switch/router in which you:
• Configure uplink-state group 3.
• Add downstream links TenGigabitethernet 0/1, 0/2, 0/5, 0/9, 0/11, and 0/12.
• Configure two downstream links to be disabled if an upstream link fails.
• Add upstream links TenGigabitethernet 0/3 and 0/4.
• Add a text description for the group.
• Verify the configuration with various
show commands.